Failsafe Brakes

These brakes are normally in the applied (Braking) condition. When electric supply is given, the brake is released and the shaft free to rotate. In case of power failure or cut off, the brake is instantaneously applied thus preventing accidents

We offer Induction Motors, Vibratory Motors, Slip Ring Motors, Torque Motors, Brake Motors, Gear Motors, and other customised drive arrangements

Shoe Type Brakes are of two types
A] Solenoid operated A.C. and D.C. Shoe Brakes
B] Hydraulic Thrustor Operated Shoe Brakes

These clutches and Brakes have a stationary coil, thus there is no need to supply power through a slip-ring & carbon brush

Clutches have slip rings. Electric supply is given through Carbon Brushes. Brakes do not have slip rings.

These multi-disc clutches / brakes work in dry as well as oil immersed condition. Used mainly in machine tools and do not require any adjustment for wear during use.

This is purely mechanical type of Brake / Clutch. When speed increases to a desired level the shoes expand thus transmitting torque in case of a clutch or bringing the unit to a halt in case of a brake.

Fluid Couplings,
Flexible Pin-Bush Type Coupling, Gear Coupling,
Geared Drum Coupling, 
Shear Pin Couplings,

Carbon Brushes, Holders, Friction Plates, Rectifier & Transformers, Crane & Hoist  accessories 

Torque up to a particular level can be transmitted, after which, in the case of an overload in transmission, the clutch / torque limitor will slip, thereby protecting the system from damage.

Unidirectional Clutches
Backstop Clutches
Freewheel Clutches
Indexing Freewheel
Overrunning Clutch

S.S. Punched grid Resistance Boxes are designed to meet requirements of A.C & D.C. application for E.O.T. Cranes, Winches, Rubber Mills, Flour Mills,

Counter weight Limit Switches are used for Heavy duty E.O.T. Cranes, Hoists to prevent over travel of hoisting motion on power and control circuit up to 500 V and 40 Amps

Lever Limit Switches are used for Heavy duty E.O.T. Cranes, Hoists to prevent over travel of hoisting motion on power and control circuit up to 500 V and 40 Amps. continuous current.

Master controllers are used for operation of contractor’s equipment controlling E.O.T. Cranes & Rolling mills drives. The controllers are made in dust proof enclosure in IP-54 degree of protection,

Rotary geared limit switch is used to trip motor supply when the moving loads reach the extreme end positions of working zone

Flame proof weather proof (FLP / WP) enclosures are constructed in accordance with provisions as specified in IS / IEC : 60079-1 : 2007 ; suitable for II B and Zone I & II atmosphere. Failsafe AC or DC disc brakes are fitted

These clutches are designed to have a stationary coil, Single surface plate and are used in dry conditions. They are light in weight, compact and have high torque at low wattage. There are three parts to a Clutch

Electromagnetic clutch brake combination is used where there is frequent start and stop. (High frequency operation) In this case the motor is kept running continuously.

These are normally Off type brakes are designed to have a stationary coil, Single surface plate and are used in dry conditions. They are light in weight, compact and have high torque at low wattage.